Superfilm for printing and transferring images (transparent)

Self-adhesive superplane for printing on a LASER printer.

A4 format sheet - 100 rubles.

Accept orders for printing of images or photos in this film according to your desire.
The cost of 1 sheet with print format A4 - 150 RUB.

Material for light surfaces is a transparent ultrathin film, which is attached to the paper (thickness 5 - 10 microns).
In this film you can print any image and transfer it to almost any surface.

The material is made in A4 format, its thickness is 5 - 10 microns, has 3 layers:
1.lacquer, which is applied to the image
2.the glue with which the image is fixed on the surface
3.the base paper (density of the base paper is 200-220 gr./m2 that allows to use the most economical laser printers).

Method of use:
This film works like decals.
1. A printout on the tape to put in the water for about 30 - 40 seconds.
2. Pull out of the water, blot excess water with a paper towel or soft cloth.
3. Gently, with one hand to move the film from the substrate by means of "shift".
4. Edge of the film is laid on the selected surface and carefully leveling and smoothing the tape to slowly move the substrate(bottom).
5. After you have removed the backing, smooth film on the surface of expelling remaining air.
6. Allow to dry naturally.
7. Remove the excess from the edges vishkarev at an angle of 45%.
8.You can now varnish.
P.S.
Sometimes, for greater strength, when applied at brashirovanie surface I coat the surface with adhesive for gilding - held tightly! In this case, you need to be careful and hang the WET film ON the NOT YET CURED ADHESIVE, because if the glue dries and becomes tacky, slide the film has not come out.
Tried an acrylic adhesive but with them a lot of air that remains under the film and it is poorly removed.